Turning Inserts That Drop In Where Your Imported Grades Did
This turning insert line covers the usual mix of workpiece materials in a shop: steel, stainless, and cast iron. WWP115/125 is built to replace imported steel grades directly. WEP115/WEP125N does the same for domestic steel grades. For stainless, go with WEU315/315N, and for cast iron, WEK115/125.
You can get them in LM, TK flat, and AM groove types, so flat turning and grooved turning are both covered. They're meant to slot into existing tooling without changing your setup.
Each part is engineered and QC'd against the exacting standards your equipment demands.
fewer part numbers to stock for mixed-material jobs
matches imported steel grades, so you can swap it in without re-qualifying your process
replaces domestic steel grades with consistent edge behavior
This turning insert line covers the usual mix of workpiece materials in a shop: steel, stainless, and cast iron. WWP115/125 is built to replace imported steel grades directly. WEP115/WEP125N does the same for domestic steel grades. For stainless, go with WEU315/315N, and for cast iron, WEK115/125.
You can get them in LM, TK flat, and AM groove types, so flat turning and grooved turning are both covered. They're meant to slot into existing tooling without changing your setup.
From mining fleets to manufacturing lines, this part ships globally and runs under load.
Proven in thousands of installations across mining, construction, energy and heavy manufacturing. Designed for 24/7 operation and backed by a responsive engineering support team.
Inspect every critical surface, tolerance and finish before you commit.
Key parameters below. Full dimensional drawings, tolerance sheets and material certificates available on request.